• Ultra energy efficient by combining aerofoil “Series 1” impeller blades and IE5* rated EC motor
• EC motor features reverse polarity protection, locked rotor protection and soft start
• No additional protection such as motor overload protection is required
• Can be manually speed controlled by pressing 2 internal motor buttons
• Can be remote speed controlled with either a 2-10V, 4-20mA,or 80-1600Hz input signal
• Can be run as an independent ventilation source or integrated into most building management systems
• Maximum operating speed can be adjusted from 1800rpm to 200rpm
• On board fault identification LED will flash according to fault type
• Integrated “Fire Mode” function forces motor to continue working under adverse conditions (at set speed)
• Guard is incorporated as standard.
• Units are light weight and can be mounted at any angle.
• Robust galvanised steel construction with polyester epoxy finish.
• Operating temperature: -20 oC to +60 oC when air velocity exceeds 5 m/s, otherwise -20 oC to +40 oC

• Ultra energy efficient by combining aerofoil “Series 1” impeller blades and IE5* rated EC motor
• EC motor features reverse polarity protection, locked rotor protection and soft start
• No additional protection such as motor overload protection is required
• Can be manually speed controlled by pressing 2 internal motor buttons
• Can be remote speed controlled with either a 2-10V, 4-20mA,or 80-1600Hz input signal
• Can be run as an independent ventilation source or integrated into most building management systems
• Maximum operating speed can be adjusted from 1800rpm to 200rpm
• On board fault identification LED will flash according to fault type
• Integrated “Fire Mode” function forces motor to continue working under adverse conditions (at set speed)
• Guard is incorporated as standard.
• Units are light weight and can be mounted at any angle.
• Robust galvanised steel construction with polyester epoxy finish.
• Operating temperature: -20 oC to +60 oC when air velocity exceeds 5 m/s, otherwise -20 oC to +40 oC

EC motors should be directly connected to their appropriate AC supply. EC motors should not be regularly power cycled.

Reverse flow: Derate the air flow by at least 25% if the air flow direction is reversed from standard. Add the suffix “R” to fan code.

* The IE5 Efficiency level is not currently defined by the IEC Standard, however the intent is for IE5 motors to have approximately a 20% reduction in losses against IE4 motors.

EC motors should be directly connected to their appropriate AC supply. EC motors should not be regularly power cycled.

Reverse flow: Derate the air flow by at least 25% if the air flow direction is reversed from standard. Add the suffix “R” to fan code.

* The IE5 Efficiency level is not currently defined by the IEC Standard, however the intent is for IE5 motors to have approximately a 20% reduction in losses against IE4 motors.

The square plate wall mounted axial fans shall be of the ECOtronic EC Series as designed and manufactured by Fantech Pty Ltd and be of the model numbers shown on the schedule/ drawings.

The axial impellers shall be made from high performance composite material. They shall be driven by an EC shaft motor with integrated speed controller and motor overload protection. Square plates shall be galvanised steel with a polyester epoxy finish.

All models shall be fully tested to ISO5801:2007 for air flow and to BS848:Part 2, 1985 for noise.